Siemens Ardoptix PT 140 AF1, Руководство по эксплуатации, Страница: 38 / 68

s
Operating manual
30
If you are using a terminal program such as HyperTerminal, set parame-
ters for the serial interface as follows:
When using a terminal software, e.g. Hyperterminal, enter the parame-
ters manually as follows:
57600 Baud / 8 Data bits / odd parity / 1 stop bit /
no handshake

After enabling the interface and selecting parameter settings, the pyrom-
eter will automatically transmit data via serial interface (autoprint activat-
ed).
19 Remote configuration
Pyrometer setup and temperature monitoring can be configured from a
PC running a simple serial terminal such as HyperTerminal. Many key
parameters can be easily accessed from a keyboard. Additional func-
tions and settings can be programmed from cascading submenus, as
shown in the menu navigation chart below:
To set the pyrometer to the terminal mode, simultaneously hold down the
Ctrl key and press the E key twice in rapid succession.
A help menu will appear on the screen.
Main Menu
Submenu 1
Submenu 2
Execute the
command
Execute the
command
Execute the
command
press
[RETURN]
or [ESC]
press
[RETURN]
or [ESC]
press
[RETURN]
or [ESC]
Select [KEY]
Select [KEY]
Press []
Backspace
Backspace
Enter
Enter
Enter
[ESC]
[ESC]
Serial communication starts approximately 2 seconds after the
data terminal ready (DTR) control signal is enabled at the inter-
face. Activate this signal in the terminal program or device con-
figuration