/PERATING INSTRUCTIONS
6+
6
# ' #
0UTTING THE RELAY INTO OPERATION
!LL SETTING VALUES SHOULD BE CHECKED AGAIN IN CASE
THEY WERE ALTERED DURING THE TESTS 0ARTICULARLY CHECK
THAT ALL DESIRED FUNCTIONS HAVE BEEN PROGRAMMED IN
THE CONFIGURATION PARAMETERS ADDRESS BLOCK RE
FER TO 3ECTION AND ALL DESIRED FUNCTIONS HAVE
BEEN SWITCHED
/.
4HE COUNTERS FOR CIRCUIT BREAKER OPERATION STATISTICS
SHOULD BE ERASED ADDRESS BLOCK REFER TO 3ECTION
0USH THE KEY
-3
ON THE FRONT 4HE DISPLAY SHOWS
THE BEGINNING OF THE ANNUNCIATION BLOCKS 4HUS IT IS
POSSIBLE THAT THE MEASURED VALUES FOR THE QUIESCENT
STATE OF THE RELAY CAN BE DISPLAYED SEE BELOW
4HESE VALUES HAS BEEN CHOSEN DURING CONFIGURATION
REFER TO 3ECTION UNDER THE ADDRESSES
AND
3TORED INDICATIONS ON THE FRONT PLATE SHOULD BE RESET
BY PRESSING THE PUSH BUTTON 2%3%4 ,%$ ON THE
FRONT SO THAT FROM THEN ON ONLY REAL FAULTS ARE INDI
CATED &ROM THAT MOMENT THE MEASURED VALUES OF
THE QUIESCENT STATE ARE DISPLAYED $URING PUSHING
THE 2%3%4 BUTTON THE ,%$S ON THE FRONT WILL LIGHT
UP EXCEPT THE "LOCKED ,%$ THUS A ,%$ TEST IS
PERFORMED AT THE SAME TIME
#HECK THAT THE MODULE IS PROPERLY INSERTED 4HE
GREEN ,%$ MUST BE ON ON THE FRONT THE RED ,%$ MUST
NOT BE ON
#LOSE HOUSING COVER
!LL TERMINAL SCREWS
EVEN THOSE NOT IN USE
MUST
BE TIGHTENED
)F A TEST SWITCH IS AVAILABLE THEN THIS MUST BE IN THE
OPERATING POSITION
4HE AUTO RECLOSE RELAY IS NOW READY FOR OPERATION
