© Siemens AG • 07/2003
3
The manufacturer of this surge arrester
Siemens AG
Power Transmission and Distribution Group
High Voltage Division
has introduced and applies a quality system in accordance with
DIN ISO 9001 / EN 29 001
Quality systems: Model for quality assurance This system was first demonstrated in 1989 to the
DQS (German Association for the Certification of Quality Systems).
The
electrical testing laboratories
and the
materials technology laboratories
of the manufacturer
have been certified since 1992 by the German Accreditation Body in accordance with
DIN EN 45 001.
If you require further copies of the operating instructions, please order them from the appropriate Siemens office,
indicating the title and order number shown on the title page.
Published by:
In case of request:
Siemens AG
Telephone ex49 / 30 / 386 1
PTD H 4
Sales department:
+49 / 30 / 386 23061
D-13623 Berlin
Fax:
+49 / 30 / 386 26721
e-mail:
Subject to change.
Note
The equipment covered by these instructions should be installed and serviced only by
competent personnel familiar with good safety practices. This instruction is written for
such personnel and is not intended as a substitute for adequate training an experience in
safe procedures.
This information is intended for the correct installation of this product. Siemens has no control over the condi-
tion of the network, which can be greatly affected by the installation of a product. It is the responsibility of the
user to chose the appropriate method of installation. Under no circumstance is Siemens liable for any direct or
indirect damage caused by the use or misuse of this product.
