GAMMA instabus
Technical Product Information
August 2013
Binary input device N 262E01
5WG1 262-1EB01
8x potential-free contacts
Technical Manual
N 262E01, 4 pages
Siemens AG
Infrastructure & Cities Sector, Building Technologies
Update: http://www.siemens.de/gamma
Siemens AG 2013
Control Products and Systems
Subject to change without further notice
P.O. Box 10 09 53, D-93009 Regensburg
2.7.3.2/4
Attaching the bus terminal (Figure 3)
Insert the bus terminal into the guide slot and press the
bus terminal (D2) backwards until it reaches the stop po-
sition.
D1
D2
D2
D2.4
D2
D2.4
5 mm
D2.1 D2.2
2
D2.3
D
Figure 3: Attaching / removing the bus terminal
Mounting the insulating cap
If the device is to be mounted on a DIN rail without a
data rail, then the contact system must be covered using
the supplied insulating cap.
Removing the locating clamp (Figure 4)
-
The locating clamp (E3) encloses the contact system
(E2) on the rear of the device (E1).
-
Insert the screwdriver between the DIN rail mounted
device (E1) and the locating clamp (E3) and remove
the clamp.
Clipping on the insulating cap (Figure 4)
-
Place the insulating cap (E4) on the contact system and
press so that it snaps into place.
Figure 4: Covering the contact system
Dimension drawing
Dimensions in mm.
b
9
0
44
55
4
5
b = 6 module units
1 module unit (MU) = 18 mm
General notes
The operating instructions must be handed over to the
client.
Any faulty device is to be sent together with a return de-
livery note of the local Siemens office.
If you have further questions concerning the product
please contact our technical support.
Technical Support
+49 (911) 895-7222
+49 (911) 895-7223
www.siemens.de/automation/support-request
E3
E1
E2
E2
E4 E1
