Siegenia AERO AEROMAT VT WRG 1000 smart, Оригинальная инструкция по эксплуатации

Страница: 8 / 24

03.2021 8/24 H47.FENS037EN-03
AERO
Original operating instructions
AEROMAT VT WRG 1000
7.4 Installation sequence
1. Remove.the. AEROMAT VT WRG 1000 .carefully.from.
the.packaging.and.do.not.place.it.on.the.weather.
grille.or.front.panel..We.recommend.storing.the.unit.
on.a.soft.surface.(e.g..cardboard.or.sheet).during.
installation.
2. Close.the.sliders.on.the.front.to.prevent.dirt.(e.g..
dust).from.entering.the.unit.during.installation..If.
the. AEROMAT VT WRG 1000 .does.not.have.sliders,.
tape.up.the.recesses.in.the.front.panel.with.film.
3. Make.sure.that.no.dirt.and.liquids.can.get.inside.the.
AEROMAT VT WRG 1000 .including.the.weather.grille.
prior.to.the.installation.of.the.exterior.insulation.or.
cladding.
According.to.the.installation.location,.it.is.
therefore.necessary.to.adhere.the.
AEROMAT VT WRG 1000 .at.points.where.rain.
could.permeate.
AEROMAT VT
Film
Adhesive.tape
Exterior.insulation
Adhesive.tape
Example:."concealed.installation.in.the.wall
with.wall.duct"
AEROMAT VT
Exterior.insulation
Film
Adhesive.tape
Adhesive.tape
Example:."concealed.installation.in.the.lintel"
4. AEROMAT VT WRG 1000 .Install.the.in.its.intended.
installation.position.and.seal.it.in.accordance.with.
the.installation.directives.applicable.on.site.
5. Check. AEROMAT VT WRG 1000 .for.cleanliness.
prior.to.starting.it.up..Clean.if.necessary.(see.
"maintenance.and.care".on.page. 17 ).
Only.drill.in.through-holes.for.wall.plugs.and.
screws.in.the.area.indicated.(see.marker.tape).
Remove.any.marker.tape.that.is.visible.after.
installation.
Prior.to.stopping.work.or.while.work.is.
interrupted,.protect.open.ends.or.areas.so.
that.no.dust.or.moisture.can.enter.