Siebring 7500S, Инструкция по эксплуатации

Страница: 8 / 40

General Operating Instructions
1. Check Oil Level (See Honda gas engine Owner’s Manual for
additional information).
2. Check CAT pump oil level. Oil level must be up to the red
center dot (see CAT Service Manual).
3. Connect pressure water supply hose or immerse suction hose
in adequate clean water supply. Be sure screen is in place.
4. Connect electrical power
A. Burner 120VAC
B. Pump Motor 220VAC (specified phase)
5. Check engine fuel supply if applicable.
6. Hot washer - check burner fuel tank for adequate fuel supply
(#1 or #2 Heating Oil). Do not use kerosene or bio-diesel.
7. Installed on each washer is a square soap container box that
will accept a one gallon jug. Most products need to be diluted
prior to use. Powered soaps are unacceptable.
WARNING: Secure gun and lance prior to starting the pump.
CAUTION: Momentarily open the gun valve to relieve pressure prior
to starting the pump motor or engine.
8. Start the pump motor.
9. Hot washer – Ignite burner with control switch (see Beckett
AFG manual for additional burner information).
10. Soap (Dema) injector – Adjust metering screws for adequate
flow (see page 7 for additional info).
11. Temperature controller/thermostat – Adjust water temperature
to desired operating level.
12. Check pump operating pressure. Do not exceed
manufacturer’s recommended pressure. Begin cleaning.
6