SIEB & MEYER Drive System SD3 Series, Описание аппаратуры

Страница: 35 / 85

7 Option Modules
The option modules are not part of the standard configuration of the basic
device. You can oder the option modules at SIEB & MEYER.
A slot for an option module is located under each screwed front panel cover (Option A
and Option B).
Mounting an option module
NOTICE
Live parts
Mounting and demounting an option module during operation can cause damage
to the module.
Switch the device into the de-energized state before inserting or removing a
module.
➮ First remove the front panel cover of corresponding slot . For this purpose remove
the two M3 bolts (3×4, Torx, raised head).
➮ Insert the option module carefully into the slot. Ensure the correct position of the
module!
➮ The front panel of the module be aligned correctly on the front panel of the device!
This ensures correct positioning of the module.
➮ Fix the option module with the two knurled screws of the option module.
Important note: Use a manual screwdriver to fix the screws. Do not use an electric
screwdriver.
7.1 Option A
At present the following modules are available for the slot Option A:
SIEB & MEYER article number Description
036 31 0044A1 EtherCAT Slave Interface
036 31 0044A2 CAN Bus Slave Interface
7.1.1 036 31 0044A1: EtherCAT Slave Interface
EtherCAT slave interfaces X28 (input) and X29 (output) for connection to a higher-
ranking control
W
Option Modules
Drive System SD3 - Hardware Description 35
7