SIDESHIFT INSTALLATION GUIDE
V1.9
20
CONNECTING WIRELESS JOYSTICK
AND ACTUATOR CONTROLS
Model HB350
Refer to HB350 schematic on page 10 for complete system layout
1.
Position the wireless control module in a dry location near the motor
control module.
2.
Connect the red(Positive) and black(Ground) leads from the 4 pin motor
control cable to the “12v Positive” and “Common Ground” terminals on
the battery bank.
Caution: DO NOT connect red and black leads directly to motor
control module or damage to wireless control module will occur.
3.
Connect “24v positive” and “Common Ground” terminals on the battery to
“battery neg” and “battery pos” on the motor control module.
4.
Connect the green and blue leads from the 4 pin motor control cable to
“switch 1” and “switch 2” on the motor control module.
5.
Plug the 4 pin motor control cable into the black wireless control module.
6.
Plug the 6 pin actuator cable into the black wireless control module.
NOTE:
The joystick and wireless key fob are preprogrammed for operation.
No pairing or programming is required.