6
PJC-222
1.0.6 - 2012
STOP
front s_v strek_PJC222.pdf 1 04.11.2010 11:05:34
MENU SYSTEM:
Access menu system by pressing and holding menu button
(‘ON’ button) for 3 seconds
Move around in menus by using joysticks
Follow instructions on the screen and press buttons as indicated on
LCD screen
STABILIZER
STABILIZER
(Shown only for yachts equipped with a Side-Power Stabilizer system)
STABILIZER: Switches the stabilizer ON or OFF.
AnySpeed: Switches the AnySpeed function ON or OFF.
OK:
Changes stabilizer setting and returns to main menu.
Select:
Selecting parameter.
Cancel:
Returns to main menu without changes.
Use stern joystick to make changes.
LANGUAGE
LANGUAGE
Choose language by moving joystick:
English, Norwegian, German, French, Spanish and Italian.
OK:
Saves language setup and returns to Main Menu
Cancel: Returns to “SETUP”-menu without saving changes
SETUP
SETUP
Use stern joystick to choose function
Select: Opens selected function
Cancel: Returns to Main Menu
PUMP SETUP
Cooling Pump: The cooling pump can be selected to ON or Auto
When Auto is selected the cooling pump will start operation when
the oil temperature reaches 50°C and stop when the oil temp
drops below 40°C.
PUMP 1 (PTO mounted): Pump 1 can be set to OFF, ON or AUTO.
When pump 1 is set to auto, the pump is on when any panel is
turned on and off when all panels are off. This can be used to
control a hydraulic AC motor power pack or electric clutch.
PUMP 2 (PTO mounted): Pump 2 could be set to ON or AUTO. When
Pump 2 is set to auto and SPS stabilizers are running, the pump will
start automatically when the oil pressure drops below 80 Bar and
keep running for 15 min. or as long as the thrusters are running.
When SPS stabilizers are inactive, Pump 2 will run all the time.
The AUTO function is used for reduced energy consumption while
SPS Stabilizers are running.
NB: only to be used with PHC24 controller with firmware
1.008 or newer!
HOLD CALIBRATION
Calibrates the HOLD-function to get balanced thrust from the
bow and stern thruster.
Start: Starts calibration. An instruction explaining the
calibration procedure will be shown on the display. In
some languages it will be necessary to press “More” to
read the complete instructions.
Press port or starboard “HOLD”-button for calibration in
the desired direction This will make both thrusters run in
the selected direction. Adjust amount of bow thrust
with bow joystick and stern thrust with the stern joystick
until a balanced thrust is achieved
