Side-Power 90077, Руководство по установке

Страница: 7 / 16

7
3006 2 2019
-
Stern Installation
MC_0142
HYD Stern Thruster Measurements
EN
Measurement
code
Measurement description
mm inch mm inch mm inch mm inch mm inch mm inch mm inch
A Length inside hull 172 6.77 172 6.77 91 3.58 195 7.68 305 12.01 257 10.12 257 10.12
B Length of external tunnel 256 10.08 300 11.81 340 13.39 420 16.54 422 16.61 540 21.26 540 21.26
C Minimum depth center of tunnel to waterline 150 5.91 215 8.46 250 9.84 300 11.81 300 11.81 380 14.96 380 14.96
D Maximum allowed Hull thickness 35 1.38 54 2.13 60 2.36 60 2.36 60 2.36 54 2.13 54 2.13
* Tunnel Length 337 13.27 330 12.99 350 13.78 456 17.95 456 17.95 550 21.65 550 21.65
Measurement
code
Measurement description
mm inch mm inch mm inch
A Length inside hull 400 15.75 405 7.28 470 18.50
B Length of external tunnel 535 21.06 705 0.24 820 32.28
C Minimum depth center of tunnel to waterline 620 24.41 770 30.31 915 36.02
D Maximum allowed Hull thickness 140 5.51 120 4.72 145 5.71
* Tunnel Length 700 27.56 850 33.46 860 33.86
* 100
* 700
* 160
* 1000
* 240
* 1400
* 320 * 400 * 420 * 550
MG_0160
Waterline
max
A
B
D
max
C
MC_0036
Positioning the stern truster
EN
Install the thruster as deep as possible on the vessel’s transom (Fig. 1).
The tunnel should be installed as deep under the waterline as possible for two reasons:
1. So that it does not suck air down from the surface which will reduce performance and increase noise levels.
2. To get as much water pressure as possible to receive maximum effi ciency from the thruster.
Generally, the top of the tunnel should be a minimum of 1/2 x the tunnel diameter below the waterline. For best performance, the distance should be 1/1
x tunnel diameter below the waterline.
Stern thruster installation for shallow vessels (Fig. 2).
When installing in shallow hull vessels, add stern cowls to the installation process.
See next page
MG_0018
1/
1
Ø
1/
1
Ø
standard stern thruster tunnel installation
Stern thruster and cowl installation for shallow vessels