- 14 -
10 - MAINTENANCE
11 - REPLACEMENT OF THE HOSE
IMPORTANT: Any maintenance operation shall be carried out by a suita-
bly trained staff, following carefully the information given in this manual.
Ensure that there is no tension in the spring before starting any opera-
tions inside the hose reel.
Always close the feeding of fluid to the machine before carrying out any maintenance on it.
Replace the flexible hose as soon as it shows any sign of wear and tear or of deterioration
due to the different conditions of the labour environment. We advise you to replace it every
year in case it is used for a few hours a week.
Replace the seal inside the revolving joint in case of losses due to wear and tear.
Any replacement of hose reel parts has to be done using original spare parts (see the spare
parts list).
We advise you to contact the manufacturer for any possible anomaly and before replacing
any part. After every maintenance operation, put again the eventual supports.
Replace the hose with another one of the same di-
mensions and characteristics.
11.1) Remove the hose rubber stopper and release
the hose slowly until the spring is completely
unloaded.
11.2) Loosen the swivel joint.
11.3) Loosen the two screws of the spring likage
shaft by a 10 wrench.
11.4) Disassemble the 4 screws which lock the two
side bodies. Take out the side body and the
rollers support and unwind completely the
hose from the drum.
11.5) Take out the drum, unscrew the internal fitting
with the suitable wrench and mount the new
hose.
11.6) Assemble again the hose reel, by following
the above steps in reverse order. If that is the
case, grease the supports and the ratchet
hook. Put the hose rubber stop at about 50 cm
from the opposite end of the hose.
11.7) Go on as indicated at point 7.2 of the chapter:
Mounting of the hose.
WARNING! For safety reasons, ope-
rations of hose replacement must be
carried out at the bench.
GB
11.3
11.4
11.1
11.2
11.5
