EN SICO KITCHENWARE®
NATURAL LABORATORY FOR VACUUM PACKAGE EN
MANUFACTURER : BISVA SRL TITO PZ ITALIA
5
ACCESSORIES CARE
All accessories must be cleaned carefully before being used. It is advisable to use warm water and mild
dishwashing soap.
TROUBLESHOOTING
PROBLEM
SOLUTION
Even if the general switch (1)
is placed on position ON, it
does not lighten.
Make sure that the plug is properly inserted in the socket.
Make sure that the cable and/or the plug are not damaged.
Make sure that the plug supplies electric energy.
The packer works but it does
not suck air.
Make sure that the lid and the gasket of the filter (see th
e paragraph “
Maintenance of the pump protection filter
“) are properly placed and cleaned.
If you are using bags, make sure that they are properly inserted under the
bracket (14) and there are not piercings.
If you are using containers, make sure that the valve and the gasket of the lids
are properly placed and cleaned.
Make sure that lids and containers do not present cracks or holes.
When
the
cycle
(sealing) is finished,
air gets into bags and/or
containers.
Bags:
•
make sure that they are not pierced.
•
check the sealing because rests and/or wrinkles in the sealing area
could cause the loss of vacuum. In this case, open the bag and
repeat the suction and sealing cycle.
•
When vacuum-packing food with points or protrusions, remember to
wrap it in soft paper napkins and/or silver paper to prevent
protrusions from piercing the bag.
•
Fermentation and/or natural release of gas from the food vacum-
packed could reinflate the bag. Do not eat the food.
Containers:
•
check that the valve and the gaskets are properly placed and
containers and lids do not present cracks or holes.
•
check that the rim of the container is not damaged in the adherence
area of the lid.
The sealing bar melts and/or
cuts the bag.
Reduce the sealing time. The packer is designed for continuous use. However,
it is better to reduce the sealing time opportunely to avoid useless waste of
electric energy.
You
cannot
identify
the
problem.
Do not try to repair the packer by yourselves. Adress the dealer.
CLEANING AND MAINTENANCE
Proper maintenance and cleaning are necessary. Firstly, you must unplug vacuum packer. Use mild, non-
abrasive and/or solvent detergents to clean external surfaces. Remove carefully any possible scraps of the bag
from the silicone gasket and the sealing bar. Pay great attention to the cleaning of the upper and lower foam
rubber gaskets and put them back correctly into their place.