Activities
Qualification
Commissioning, configura‐
tion
■
Basic knowledge of the Windows
TM
operating system in use
■
Basic knowledge of the design and setup of the described con‐
nections and interfaces
■
Basic knowledge of data transmission
Operation of the device for
the particular application
■
Knowledge of the operation and control of the devices in their
particular application
■
Knowledge of the software and hardware environment for the
particular application
2.7
Operational safety and particular hazards
Please observe the safety notes and the warnings listed here and in other chapters of
this product documentation to reduce the possibility of risks to health and avoid dan‐
gerous situations.
CAUTION
Optical radiation: Laser class 1
The accessible radiation does not pose a danger when viewed directly for up to 100
seconds. It may pose a danger to the eyes and skin in the event of incorrect use.
■
Do not open the housing. Opening the housing may increase the level of risk.
■
Current national regulations regarding laser protection must be observed.
CAUTION
Hazardous radiation.
If any operating or adjusting devices other than those specified here are used or other
methods are employed, this can lead to dangerous exposure to radiation. Damage to
the eyes is possible.
■
If the product is operated in conjunction with external illumination systems, the
risks described here may be exceeded. This must be taken into consideration by
users on a case-by-case basis.
■
Do not look into the light source when it is switched on.
■
Comply with the latest version of the applicable regulations on photobiological
safety of lamps and lamp systems as well as on laser protection.
WARNING
Electrical voltage!
Electrical voltage can cause severe injury or death.
■
Work on electrical systems must only be performed by qualified electricians.
■
The power supply must be disconnected when attaching and detaching electrical
connections.
■
The product must only be connected to a voltage supply as set out in the require‐
ments in the operating instructions.
■
National and regional regulations must be complied with.
■
Safety requirements relating to work on electrical systems must be complied with.
SAFETY INFORMATION
2
8022069/114M/2019-07-17 | SICK
O P E R A T I N G I N S T R U C T I O N S | MRS6000
9
Subject to change without notice