42
6 Set up with the display and adjustment module
LBR • Two-wire 4 … 20 mA/HART
62273-EN-200520
The default setting for the display value is "
Percent
".
The display and adjustment module has a backlight for the display. In
this menu item you can switch the lighting on or off. You can find the
required operating voltage in chapter "
Technical data
".
To maintain the function of the device, the lighting is temporarily
switched off if the power supply is insufficient.
In delivery status, the lighting is switched on.
In this menu item, the device status is displayed.
The min. and max. measured value, the measurement reliability as
well as the min. and max. electronics temperature are stored in the
sensor. The values are displayed in menu item "
Peak value
" or "
Fur-
ther peak values
".
A reset menu is opened with the
[OK]
key in the respective peak
value window:
With the
[OK]
key in the reset menu, the peak values are reset to the
current measured value.
The "
Echo curve
" shows the signal strength of the echoes over the
measuring range in dB. The signal strength enables an evaluation of
the quality of the measurement.
The selected curve is continuously updated. A submenu with zoom
functions is opened with the
[OK]
key:
•
"X-Zoom": Zoom function for the meas. distance
•
"Y-Zoom": 1, 2, 5 and 10x signal magnification in "
dB
"
Display - Backlight
Diagnostics - Device
status
Diagnosis - Peak value
Diagnosis - Curve indica-
tion
