SICK H18 - SureSense, Руководство по эксплуатации

Страница: 16 / 203

-xxxxxI
2
Q1 = L.ON
Adjustabl
e OFF
Delay
-xxxxxD
-xxxxxG
-xxxxxK 1
-xxxxxN
Q1 = D.ON
-xxxxxK
2
Q1 = L.ON
1 L/D Selection Switch in in the “D” Dark Switching position
2 L/D Selection Switch in in the “L” Light Switching position
7 Commissioning
1 Alignment
Sensor with red light:
Align sensor on object. Select the position so that the red emitted light beam hits the cen‐
ter of the object. You must ensure that the optical opening (front screen) of the sensor is
completely clear [see
figure 1 ].
Sensor with infrared light (not visible):
Align sensor on object. Select the position so that the infrared light hits the center of the
object. The correct alignment can be detected via the signal strength light bar on the back
of the sensor and the LED on the top of the sensor. See
figure 1 and table 1 . You must
ensure that the optical opening (front screen) of the sensor is completely clear.
Figure 1: Alignment
2 Sensing range
Check the application conditions: Adjust the sensing range and the remission capability of
the object according to the corresponding diagram [see
table 10 ]. (x = sensing range, y =
operating reserve).
During this process, an object can only be detected in front of a background if the remis‐
sion capability of the object is significantly higher than that of the background or if the dis‐
tance between the object and the background is sufficiently long.
7
COMMISSIONING
16
8017851.16K9 | SICK
Subject to change without notice