3
Align the position of the red light spot. To do this, adjust the nuts for the X and Y
alignment on the device flange so that the light spot in positioned in the center of
the target,
see "Optical fine alignment of the sender/receiver unit ", page 54
4
After successful alignment, push the lever of the alignment tool back to its original
position and secure it with a quarter turn.
1
2
Figure 29: Point for correct fine adjustment
1
Target for the alignment tool for the Cross-Duct version
2
Target for the alignment tool for the probe version
7.10
Installing the weatherproof cover
Installing the weatherproof cover of the sender/receiver unit:
1
Install the installation plate on the flange of the purge air fixture.
w
Lay the weatherproof cover upside down on the floor.
w
Open and unhinge the locking bolts on both sides.
w
Pull the installation plate upwards and remove it from the cover.
w
Remove the bottom mounting ring.
w
Place the installation plate onto the rubber band of the purge air fixture from
the top.
w
Position the mounting ring on the side of purge air fixture.
w
Screw the bottom mounting ring to the top mounting ring.
COMMISSIONING
7
8019532/100Q/V1-1/2018-08 | SICK
O P E R A T I N G I N S T R U C T I O N S | GM700 Ex
55
Subject to change without notice