SICK DEFOR, Дополнительные инструкции по эксплуатации, Страница: 16 / 30

16 DEFOR · Supplementary Operating Instructions · 8013029 V2.0 · © SICK AG
Functions in SOPAS ET
Su
bj
ec
t t
o c
han
ge
w
ith
ou
t n
ot
ic
e
4.2
Explanation of the menus in SOPAS ET
No.
Description Explanation
1 Component Name of measuring component
2 Measured value Actual measured value of measuring component
3 Unit Physical unit of measured value
4 Failure LED symbol
●
Significance: Module not ready for operation
●
Possible causes: Malfunction, defect
Maintenance request LED symbol
● Significance: Advance warning before internal technical
limits reached.
● Possible causes: Drift limit, operating hours, lamp intensity
Function(s) active LED symbol
●
Significance: At least one internal function active that
impairs or hinders normal module measuring function.
●
Possible causes: Adjustment procedure running, validation
measurement running
Uncertain state LED symbol
● Significance: Actual measured values are unreliable.
● Possible causes: Heating up phase, internal over/under
temperature, adjustment procedure programming not
plausible
5 Operating hours Number of operating hours of the UV lamp fitted
6 Intensity …% Actual light intensity in the reference beam path for the asso-
ciated measured component (with the specific optical filter in
the beam path) relative to the new condition of the UV lamp;
evaluated automatically (
→ [7]
; UV lamp service life → p. 26,
5.7)
7 Failure UV lamp status (evaluation of intensity); “OK” = full intensity,
“Maintenance” = UV lamp replacement recommended;
“Uncertain” = correct measuring function questionable; “Fail-
ure” = measurement no longer possible. The module status
flags are activated accordingly (
→ [4]
).
Uncertain
Maintenance
OK
8 Description Freely selectable text for module name
9 Module address Internal CAN bus address of module (defined by hardware set-
ting in module)
10 Baud rate Transfer speed (standard: 9600)
Data bits Number of data bits (standard: 8)
The GMS800 only uses the 7-bit range (ASCII code 0 … 127)
but can also communicate in 8-bit format.
Stop bits Number of stop bits (1 or 2; standard: 2)
Parity Additional identification for automatic monitoring of character
transfers; [Even], [Odd], [None]. – Standard: None
11 Actual Internal operating module state:
● [Heating] = heating up phase (measured values unreliable)
● [Measuring] = measuring operation (normal operating
mode)
● [Halt] = stopped electronically (not ready for operation)
12 Target Default operating mode through entry or software function;
should become actual operating mode after a certain time
(can take up to 1 hour during the heating up time after start-
up).
13 Start value Start value of physical measuring range
14 End value End value of physical measuring range
15 Base value Internal physical base value of measuring range
16 Measuring channel Internal measuring channel for measuring component