2
Safety information
2.1
Intended use
Basic connection module for connecting a SICK identification sensor (ID sensor) to a
host, CAN sensor network, peripheral devices, and voltage supply. To do so, the ID
sensor needs to be connected to the externally accessible M12 female connector of
the connection module using a SICK standard cable. The voltage supply is delivered via
cable glands and terminals, and the signals are distributed on cables.
Supported ID sensors
•
Fixed mount bar code scanner CLV62x to CLV64x (type-dependent), CLV69x
•
Lector® series
•
RFID read/write device
2.2
Improper use
Any use outside of the stated areas, in particular use outside of the technical specifica‐
tions and the requirements for intended use, will be deemed to be incorrect use.
•
The device does not constitute a safety component in accordance with the respec‐
tive applicable safety standards for machines.
•
The device must not be used in explosion-hazardous areas, in corrosive environ‐
ments or under extreme environmental conditions.
•
Any use of accessories not specifically approved by SICK AG is at your own risk.
WARNING
Danger due to improper use!
Any improper use can result in dangerous situations.
Therefore, observe the following information:
■
Product should be used only in accordance with its intended use.
■
All information in these operating instructions must be strictly observed.
■
Shut down the product immediately in case of damage.
2.3
Limitation of liability
Relevant standards and regulations, the latest technological developments, and our
many years of knowledge and experience have all been taken into account when
compiling the data and information contained in these operating instructions. The
manufacturer accepts no liability for damage caused by:
■
Non-adherence to the product documentation (e.g., operating instructions)
■
Incorrect use
■
Use of untrained staff
■
Unauthorized conversions or repair
■
Technical modifications
■
Use of unauthorized spare parts, consumables, and accessories
With special variants, where optional extras have been ordered, or owing to the latest
technical changes, the actual scope of delivery may vary from the features and illustra‐
tions shown here.
SAFETY INFORMATION
2
8021689/ZZN2/2021-05-07 | SICK
O P E R A T I N G I N S T R U C T I O N S | CDB650
7
Subject to change without notice
