pg. 5
©Copyright Siborg Systems Inc.
C
‘Capacitance’ measurement mode
R
‘Resistance’ measurement mode
100 Hz
100 Hz test frequency
1 kHz
1 kHz test frequency
10 kHz
10 kHz test frequency
AC
Automatic circuit mode selection
Battery level indicator
Measurement Units
The following table outlines the primary display measurements
Measurement Units Display
Legend
Description
M
Mega 1E+06 (1000000)
K
Kilo 1E+03 (1000)
m
Milli 1E-03 (0.001)
u
Micro 1E-06 (0.000001)
n
Nano 1E-09 (0.000000001)
p
Pico 1E-12 (0.000000000001)
uH, mH, H
Henry, units for inductance measurement
pF, nF, uF, mF
Farad, units for capacitance measurement
mΩ, Ω, kΩ, MΩ
Ohm, units for resistance and impedance measurement
Hz, kHz
Hertz, units for frequency measurement
Care and Maintenance
Warning
: To avoid electrical shock or damage to the device, keep the insides of the housing dry.
Use damp clothes with little to no extra moisture. Be sure that all parts are dry before storage.
The LCR-Reader may need cleaning or maintenance after an extended period of time.
To clean the device, wipe down with a damp, gentle cloth. Be sure to not have extra moisture left on
the device.
Clean the case out with a damp cloth and mild detergent.
To clean the tips, screws and arms wipe with rubbing alcohol.
The tips may wear out over time due to use; this may cause readings to be slightly inaccurate. To
replace the tips, remove the screws and washers and remove the tips. Wipe the arms down with
rubbing alcohol as to remove any debris. Replace the tips.
Note: when replacing the tips, turn the device on and pay attention to the screen. If the device
shows a reading, remove the tips again and wipe down with alcohol. Sometimes debris gets caught
between the arms and tips causing the device to show values.
Содержание LCR-Reader
Страница 1: ......
