Sibeam Snap MOD6212, Руководство по установке

Страница: 4 / 16

Module Installation Guide
4 ©2017 SiBEAM, Inc., a Lattice Semiconductor company.
All rights reserved. CONFIDENTIAL
MOD6212/13 Transceiver Module Pinout
Table 1. Signal pinout
Pin Name Type Dir Group Description
1 3V3 Power Input Power 3.3V +/-5% power supply
2 SCL Digital In/Out
O.D.
I
2
C I
2
C Clock, Tunneling port. SB6210/SB6212 Connect to
Master; SB6211/SB6213 Connect to Slave
3 3V3 Power Input Power 3.3V +/-5% power supply
4 SDA Digital In/Out
O.D.
I
2
C I
2
C Data, Tunneling port. SB6210/SB6212 Connect to Master;
SB6211/SB6213 Connect to Slave
5 3V3 Power Input Power 3.3V +/-5% power supply
6 SCL_DBG I2C Bi-Dir USB I
2
C Data, Debug port. Connection to debug controller not
required for normal operation.
7 GND Power Power Ground
8 SDA_DBG I
2
C In/Out
O.D.
Debug I
2
C Data, Debug port. Connection to debug controller not
required for normal operation.
9 GND Power Power Ground
10 GPI Digital Input GPIO General purpose input. Status of this input is reflected on
the GPO pin on the opposite side of an active wireless link.
11 WAKE_UP Digital Input Control Force the link to W0 State. This is useful to bypass USB states,
when I2C tunnel or GPI signal needs to be used, while the link
is in low power states. Active High. Optional.
12 VBUS_SENSE Digital Input USB USB VBUS status input , 3V3
13 ATB_N Analog Output Debug Differential analog test bus - negative terminal
14 GND Power Power Ground
15 ATB_P Analog Output Debug Differential analog test bus - positive terminal
16 SSRX- Analog Input USB USB Super speed Neg Input
17 RST Digital Input Config Reset Input, active HIGH
18 SSRX+ Analog Input USB USB Super speed Pos Input
19 ID_IN Digital Input USB USB ID Input
20 GND Power Power Ground
21 ID_VAL Digital Input USB USB ID Valid Input
22 SSTX+ Analog Output USB USB Super speed Pos Output
23 ID_OUT Digital Output USB USB ID Output
24 SSTX- Analog Output USB USB Super speed Neg Output
25 VBUS_EN Digital Output USB USB VBUS status output, 3V3
26 GND Power Power Ground
27 LEDO Digital Output Config LED output
28 D+ Analog Bi-Dir USB USB High Speed/Full Speed/Low Speed Pos I/O
29 GPO/INT Digital Output GPIO General purpose output. When a wireless link is active, the
status of this output reflects the GPI pin on the opposite side
of the wireless link. Also used as I2C tunnel interupt
30 D- Analog Bi-Dir USB USB High Speed/Full Speed/Low Speed Neg I/O