I - PREPARING THE MECHANISM
II - INSTALLATION
Check the position of the stirrup
If the stirrup (m) is correctly positioned
on the basis of the below table, proceed
to step
➏
. Otherwise, carry out all of the
following steps:
➊
Unclip the lift rod (c)
➋
Remove the stirrup (m) , by pressing on
the two catch clips (k)
➌
Cut the overflow (l) if necessary according
to the table
➍
Reposition the stirrup in its seat and slide
it to the required position (desired setting
notch number visible)
➎
Clip lift rod (c) back into the hole of the
overflow (l) which has the same number as
that of the setting notch
➏
Unscrew the strainer nut (f)
Measure the cistern
-H (from the top of the lid to the inside base of the cistern)
-D (diameter of the hole in the lid)
Height
H
of cistern
Diameter
D
Diameter
D
of hole in lid
of hole
18 to 38 mm
in lid
and
38 to
45 to 50 mm
44 mm
11 430 to 417
448 to 435
10 416 to 405
434 to 423
9 404 to 393
422 to 411
8 392 to 381
410 to 399
7 380 to 369
398 to 387
6 368 to 357
386 to 375
5 356 to 345
374 to 363
4 344 to 333
362 to 351
3 332 to 321
350 to 339
2 320 to 309
338 to 327
1 308 to 297
326 to 315
Mini 296 to 282
314 to 300
No. of notch visible on lift r
od
H
D
➌
➍
➎
Stirrup notch
Cut on overflow tube
3
C mark visible
2
F mark visible
1
I mark visible
Mini
L mark visible
Position the mechanism
in the cistern and secure
it in place with the nut (f)
Manually screw the
flush valve nut (f) until
it is in contact with
the ceramic. If
necessary give an
extra quarter turn
(maximum) with the
appropriate spanner.
NB : Excessive
tightening can damage
the mechanism and
would not be covered by
the guarantee.
➊
➋
➊
+
➋
=
Visible stirrup notch
no. 4
= position of lift rod
no. 4