E7014
Tel. +39 035 6227411 - Fax +39 035 6227499
www.esapyronics.com - [email protected]
Limited Company - Share Capital Euro 153.111,00 paid up
V.A.T. number: IT 00793030164
Fiscal number: 03428410157
Registered Office
Via Canovine, 2/4 - I-24126 Bergamo, Italy
Registro Imprese di Bergamo n° 03428410157
R.E.A. n° 173124
Export: BG0061150
1
ESA S.r.l.
Via E. Fermi, 40
I-24035 Curno (BG), Italy
MICROPROCESSOR OPERATED BURNER CONTROL DEVICE
ESA ESTRO SERIE
INTRODUCTION
ESA ESTRO is a microprocessor operated device, designed to
control gas and oil fired burners, discontinuously operated.
This device warrants the safe operation of combustion unit at
one or two stages (pilot and main burners), it controls the air
flow rate and allows the detection of flame presence through
ionization (electrodes) or UV radiation (UV-scan).
ESA ESTRO is equipped for serial communication, allowing a
remote burner control and operation. The thermal resistant
case of ESA ESTRO allows its installation on burner proximity,
provided the environment temperature will remain below 60°C.
APPLICATIONS
-
One or two stages (pilot and main) discontinuous burners;
-
Flame detection by means of rod, unirod and UV scan (also
combined);
-
Packaged burners managing a complete ignition cycle
(blower, air damper, air pressure switch);
-
Burners with air valve control for furnace purging, burner
ignition and thermoregulation (heating/cooling) via external
regulation device;
-
Combustion plant with burners controller via digital signal or
ECS serial communication;
-
Customized burners operation through programmable
expansion cards.
FEATURES
MAIN
• Supply voltage:
115 Vac o 230 Vac +10÷-15%
• Frequency:
45÷65 Hz
• Power Supply Mode
phase-neutral, non suitable for phase-
phase
• Neutral Type
suitable for ground as well as non
ground neutral connection
• Power consumption (without outlets):
4 VA max
• Operating temperature:
0÷60 °C
• Storage temperature:
-20÷80 °C
• Protection class:
IP54 (when wiring, use adequate
connectors)
• Mounting position:
any
• Installation Environment
not suitable for ATEX classified area
and corrosive area
• Case
Thermosetting with glass fiber
• Size
200×120×93 mm
• Weight
1.300 g
