Si-tex NAVSTAR 10, Руководство по эксплуатации

Страница: 30 / 126

- 29 -
Installation of the Transducer
Mounting the Transom-Mount Transducer
Follow these instructions if you are installing the transom-mount transducer.
1
st
). On a boat with a fiberglass hull, the leading edge of the transducer should extend 1/8""(3.2mm) to
1/4""(6mm) below the bottom edge of the hull. See picture 1-3. On an aluminum hull, the transducer
should extend a bit more - 1/4"(6mm) to 3/8"(9mm). If the boat will be operated at high speeds, the
transducer may be mounted closer to the centerline of the hull.
2
nd
) The lower surface of the transducer should tilt down toward the rear at a slight angle(2° to 5°). The
mounting bracket includes a wedge. Depending on the angle of the transom on your boat, you may
need this wedge to get the correct angle for the bottom of the transducer.
3
rd
) Looking at the rear of the boat, be sure the bracket is vertical (perpendicular to the water line).
4
th
) Hold the bracket (and the wedge, if used) against the transom and trace the position of the screw
slots.
5
th
) Remove the bracket. The screws in the outer slots should be placed about 1/4"(6mm) up from
the bottom of each slot. The screw in the center slot should be placed 1/4" (6mm) down from the top.
(This will allow you to adjust the bracket up or down a bit.)
Drill pilot holes 3/4""(19mm) deep. Use a 9/64" (3.5mm) drill bit. To prevent drilling too deeply, wrap
masking tape around the drill bit about 7/8" (22mm) from the tip. Drill in only as far as the tape marker.
If you are attaching the bracket to a fiberglass hull, you can minimize any surface cracking of the gel
coat. Before drilling each pilot hole, drill a shallow hole (chamfer) at each location about 1/16" (1.5mm)
deep. Use a 1/4"(6mm) drill bit.
6
th
) Attach the bracket to the hull using the pinhead screw with flat washers. Before you tighten the
screws, apply a good-quality marine sealant to the pilot hole. This will protect the hull from water
penetration. Do not tighten the screws completely yet.