Seite
25
von
31
5. SET FUNCTIONS
You can set all functions of the device directly on the device, using the control panel, or with
the remote control.
1. STANDBY MODE
Before you switch on the device, please press the ON / OFF switch, which is located on the
right-hand side of the heating panel
the device is now ready for use, but not switched on.
NOTE
Never switch off the heating panel by pulling the plug directly from the mains.
Always press the ON / OFF switch first before disconnecting the device from the mains.
2. SET THE TIME & DATE
If you are using the device for the first time, please set the correct date and time directly on the
device as follows:
1. Switch on the device using the
button.
2. Press the
button repeatedly until the
symbol appears on the display.
3. Then press and hold the
button until the hour flashes.
4. Now set the correct hour using the
buttons.
5. Then press the
button to set the minutes. Use the
buttons again to set the
correct minute.
6. Then press the
button again to set the correct weekday.
7. Use the
buttons to select the correct day. Please pay attention to the following
symbol on the display:
1 = Monday
2 = Tuesday
Etc.
7 = Sunday
8.
Finally
, press
button to confirm your entries.
3. SET THE STANDARD TEMPERATURE
Since the device has several modes, a standard temperature must be set, which the device
always reaches as the target temperature for the selected functions. You can choose a
temperature between 5 ° C - 40 ° C.
1. Switch on the device using the
button.
2. Press the
button repeatedly until the
symbol appears on the display.
3. Now set the required standard temperature using the
buttons.
4. Confirm your temperature with
.
