- 38 -
Hot Key Power ON
Power-on by soft-on/off button and keyboard are available. The user may set power-on
hot-key from <Ctrl><F1> to <Ctrl><F12>.
KBC input clock
This item to set the input clock to onboard keyboard controller. The options are 8MHz,
12MHz and 16MHz.
Onboard FDC Controller
This item specifies onboard floppy disk drive controller. This setting allows you to
connect your floppy disk drives to the onboard floppy connector. Choose the "
Disabled
"
settings if you have a separate control card.
Onboard Serial Port 1
This item is used to define onboard serial port 1 to
3F8/IRQ4, 2F8/IRQ3, 3E8/IRQ4, 2E8/
IRQ3, Auto
or
Disabled
.
Onboard Serial Port 2
This item is used to define onboard serial port 2 to
3F8/IRQ4, 2F8/IRQ3, 3E8/IRQ4, 2E8/
IRQ3, Auto
or
Disabled
.
UART Mode Select
The main board support IrDA(HPSIR) and Amplitudes Shift Keyed IR(ASKIR) infrared
through COM 2 port. This item specifies onboard Infra Red mode to
IrDA 1.0, ASKIR,
MIR 0.57M, MIR 1.15M, FIR
or
Standard (Disabled).
Note : FIR is not available currently.
RxD , TxD Active
This item specifies the Active level for RxD & TxD signal.
IR Transmittion delay
This item enable/disable the delay of the IR state change from Rx to Tx mode or Tx to Rx
mode.
Onboard Parallel Port
This item specifies onboard parallel port address to
378H, 278H, 3BCH
or
Disabled.
Parallel Port Mode
This item specifies onboard parallel port mode. The options are
SPP
(Standard Parallel
Port),
EPP
(Enhanced Parallel Port),
ECP
(Extended Capabilities Port), and
EPP+ECP.
ECP Mode Use DMA
This item specifies
DMA
(Direct Memory Access) channel when ECP device is in use.
The options are
DMA 1
and
DMA 3
.
This item will not show up when SPP and EPP
printer mode is selected.
EPP Mode Select
This item select the EPP Mode, EPP 1.9 or EPP 1.7.
