- 38 -
IR Connector (JP18)
If you have an Infrared device, this mainboard can implement IR transfer
function. To enable the IR transfer function, follow these steps:
Pins Assignment:
1=NC
3=+5V
5=IRTX
2=KEY
4=GND
6=IRRX
Note:
Before connect your IR device, please be sure each IR on board pin
allocation is matchable with the pin of the IR device. Otherwise,
incorrect IR connection may do damage to your IR device.
Step 1.
Attach the 6-pin infrared device cable to JP18 connector.
(Refer to the above diagram for IR pin assignment.)
Step 2.
Configure the Infrared transfer mode in field "UART Mode Select"
of "Super IO Device" of "Integrated Peripheral" sub-menu in
BIOS setup program. This mainboard supports IrDA, ASKIR,
Normal transfer modes.
Wake-On-LAN Connector (JP6)
Attach a 3-pin connector through the LAN card which supports the Wake-
On-LAN (JP6) function. This function lets users wake up the connected
system through the LAN card.
Pins Assignment:
1=Power
2=GND
3=RING#
-!
-"
3 2 1
5 3 1
6 4 2
JP18
IR
1
JP6
WOL
1
