911-481 Rev. F 10/04
Page: 1 of 2
«
ISO Certified Facility
SHURflo reserves the right to update specifications, prices, or make substitutions.
SHURflo
«
5900A Katella Ave.
Cypress, CA 90630
(562) 795-5200
(800) 854-3218
FAX (562) 795-7564
Shipping:
5900C Katella Ave.
Cypress, CA 90630
SHURflo East
52748 Park Six Court
Elkhart, IN 46514-5427
(574) 262-0478
(800) 762-8094
FAX (574) 264-2169
© 2004 All Rights Reserved
www.shurflo.com
SHURflo Ltd.
Unit 5 Sterling Park
Gatwick Road, Crawley
West Sussex, RH10 2QT
United Kingdom
+44 1293 424000
FAX +44 1293 421880
MOUNTING
The Two Gallon (7.6ltr) and Six Gallon (22.7ltr) Accumulator Tank can be mounted using four proper length
3/8” (9.5mm) bolts. Be certain there is no excess stress on plumbing connections. All tanks should be
securely mounted to a solid foundation. Pump can be mounted on top of tank or beside it.
OPTIONAL APPLICATIONS
When used as a dampening device/water hammer or noise suppresser, the precharge should be set at the operating
(dynamic) pressure. Place a gauge in the offending plumbing where the accumulator can be mounted. Adjust the valve
so the noise is generated and read the pressure. Set the precharge to the observed pressure, remove the gauge, and
install the accumulator.
For applications requiring an intermittent flow rate at a given pressure, the proper precharge is the
minimum
pressure
required at the dispense valve. For example, if a system requires a minimum pressure of 30 psi [2.0 bar] (for correct
brix, etc.) the correct precharge should be set at 30 psi [2.0 bar] to permit the most reserve storage capacity. If the
precharge is higher than pump "turn
ON
", the liquid volume can be significantly less.
3400-002 SPECIFICATIONS 3400-006 SPECIFICATIONS
Maximum Pressure
100 psi [6.8 bar] - O
2
or N
2
100 psi [6.8 bar] - O
2
or N
2
Total Volume (gas/liquid)
2 gal. [7.6 lt]
6 gal. [22.7 lt]
Liquid Volume @ 20 psi charge
.7 gal [2.2 lt]
2.2 gal [9.8 lt]
Temperature Range
34-120
0
F [1/49
0
C]
34-120
0
F [1/49
0
C]
Threaded Port
1/2" FNPT
3/4” MNPT
Tank Material
Stainless Steel
Stainless Steel
Bladder Material
Butyl
Butyl
Width
11" [28 cm]
11" [28 cm]
Length
12" [31 cm]
18" [46 cm]
Listing
NSF Standard 18
NSF Standard 18
.
Typical Dimensions of 3400-002, 2 Gallon [7.6 Liter]
LIMITED WARRANTY PROCEDURE
SHURflo warrants the accumulator to be free from material and workmanship defects (under normal use and service) for a period of one (1) year from the
date of manufacture or one (1) year use, with proof of purchase, not to exceed two (2) years in any event.
The limited warranty will not apply to accumulators that were improperly installed, misapplied, or are incompatible with components or liquid not manufactured
by SHURflo. Failure due to chemical incompatibility or foreign debris is not covered under the terms of this limited warranty. SHURflo will not warrant any
accumulator that is physically damaged or altered outside the SHURflo factory.
Warranty claims may be resolved by an authorized dealer service center, or by SHURflo. Returns are to be shipped with charges pre-paid. Package all returns
carefully. SHURflo will not be responsible for freight damage incurred during shipping to a service center.
For complete limited warranty information contact SHURflo.
[28cm]
[28cm]
[24cm]
