Shure U4D, Руководство по обслуживанию

Страница: 33 / 47

Shure U4D Dual Diversity UHF Receiver
32
25D1062 (AG)
Service Procedures
Audio Level Setup, Channel A
U207
R203
P202
P202
P203
S201
ANTENNA A IN
P202
P202
P203
S201
ANTENNA B IN
RF SIGNAL GENERATOR
PIN 7
DC BLOCK
NOTE: DC VOLTAGES ARE PRESENT
AT MOST RF TEST POINTS. USE A DC
BLOCK ON THE RF SIGNAL GENERATOR
TO PROTECT TEST EQUIPMENT.
J302
(OFF) (OFF)
AUDIO ANALYZER
Figure 16. Channel A Audio Level Setup Connections
For the following test, make sure the tone key switch (S201) is OFF.
All Models (Except II and KK Models)
1. Set the rf signal generator deviation to 45 kHz and modulating
frequency to 1 kHz.
2. Connect the rf signal generator to BNC connector ANTENNA A
IN on the receiver back panel.
3. Place the (+) terminal of the audio analyzer on U207, pin 7, and
connect the (–) terminal to ground.
4. Adjust R203 until the audio analyzer reads 0.436
±
0.005 Vrms.
5. Disconnect the rf signal generator from the BNC connector
ANTENNA A IN on the receiver back panel.
II Models (Japan)
1. Set the rf signal generator deviation to 28 kHz and modulating
frequency to 1 kHz.
2. Connect the rf signal generator to BNC connector ANTENNA A
IN on the receiver back panel.
3. Place the (+) terminal of the audio analyzer on U207, pin 7, and
connect the (–) terminal to ground.
4. Adjust R203 until the audio analyzer reads 0.282
±
. 003 V.
5. Disconnect the rf signal generator from the BNC connector
ANTENNA A IN on the receiver back panel.
KK Models (United Kingdom)
1. Set the rf signal generator’s deviation to 40.0 kHz and modulat-
ing frequency to 1 kHz.
2. Connect the rf signal generator to BNC connector ANTENNA A
IN on the receiver back panel.
3. Place the (+) terminal of the audio analyzer on U207, pin 7, and
connect the (–) terminal to ground.
4. Adjust R203 until the audio analyzer reads 0.436
±
. 003 V.
5. Disconnect the rf signal generator from the BNC connector
ANTENNA A IN on the receiver back panel.