Band
Range
Transmitter output*
G4
470 - 494 MHz
30 mW
G4E
470 - 494 MHz
10 mW
G5
494 - 518 MHz
30 mW
G5E
494 - 518 MHz
10 mW
H5
518 - 542 MHz
30 mW
H5E
518 - 542 MHz
10 mW
J3
572 - 596 MHz
30 mW
K3E
606 - 630 MHz
10 mW
L4
638 - 662 MHz
30 mW
L4CN
638 - 662 MHz
30 mW
L4E
638 - 662 MHz
30 mW
P4
702 - 726 MHz
30 mW
P4CN
702 - 726 MHz
30 mW
Q24
736 - 754 MHz
30 mW
R13
794 - 806 MHz
20 mW
R19
794 - 806 MHz
10 mW
R5
800 - 820 MHz
20 mW
JB
806 - 810 MHz
10 mW
S6
838 - 865 MHz
10 mW
X4
925 - 932 MHz
10 mW
*
Conductive into 50 ohms
7
Certifications
FP1, FP2, FP3, FP5
This Class B digital apparatus complies with Canadian ICES-003. Cet
appareil numérique de la classe B est conforme à la norme NMB-003 du
Canada.
Meets requirements of the following standards: EN 300 422 Parts 1 and 2,
EN 301 489 Parts 1 and 9, EN60065.
Meets essential requirements of the following European Directives:
•
R&TTE Directive 99/5/EC
•
WEEE Directive 2002/96/EC, as amended by 2008/34/EC
•
RoHS Directive 2002/95/EC, as amended by 2008/35/EC
Note:
Please follow your regional recycling scheme for batteries and
electronic waste
FP5
Approved under the Declaration of Conformity (DoC) provision of FCC Part
15.
Certified by IC in Canada under RSS-123 and RSS-102.
IC:
616A-FP5L, 616A-FP5M, 616A-FP5A, 616A-FP5B, 616A-FP5C
FP1, FP2, FP3
Type Accepted under FCC Parts 74.
FCC:
DD4FP3L, DD4FP3M, DD4FP3A, DD4FP3B, DD4FP3C,
DD4SLX1G4, DD4SLX1G5, DD4SLX1, DD4SLX2G4, DD4SLX2G5,
DD4SLX2.
Certified by IC in Canada under RSS-123 and RSS-102.
IC:
616A-FP3L, 616A-FP3M, 616A-FP3A, 616A-FP3B, 616A-FP3C,
616A-SLX1G4, 616A-SLX1G5, 616A-SLX1, 616A-SLX2G4,
616A-SLX2G5, 616A-SLX2.
This device complies with Industry Canada licence-exempt RSS
standard(s). Operation of this device is subject to the following two condi-
tions: (1) this device may not cause interference, and (2) this device must
accept any interference, including interference that may cause undesired
operation of the device.
Le présent appareil est conforme aux CNR d'Industrie Canada applicables
aux appareils radio exempts de licence. L'exploitation est autorisée aux
deux conditions suivantes : (1) l'appareil ne doit pas produire de brouil-
lage, et (2) l'utilisateur de l'appareil doit accepter tout brouillage radioélec-
trique subi, même si le brouillage est susceptible d'en compromettre le
fonctionnement.
The CE Declaration of Conformity can be obtained from Shure
Incorporated or any of its European representatives. For contact informa-
tion please visit www.shure.com
The CE Declaration of Conformity can be obtained from: www.shure.com/
europe/compliance
Authorized European representative:
Shure Europe GmbH
Headquarters Europe, Middle East & Africa
Department: EMEA Approval
Jakob-Dieffenbacher-Str. 12
75031 Eppingen, Germany
Phone: 49-7262-92 49 0
Fax: 49-7262-92 49 11 4
Email: [email protected]
LICENSING INFORMATION
Licensing: A ministerial license to operate this equipment may be required
in certain areas. Consult your national authority for possible requirements.
Changes or modifications not expressly approved by Shure Incorporated
could void your authority to operate the equipment. Licensing of Shure
wireless microphone equipment is the user’s responsibility, and licens-
ability depends on the user’s classification and application, and on the
selected frequency. Shure strongly urges the user to contact the appropri-
ate telecommunications authority concerning proper licensing, and before
choosing and ordering frequencies.
Note:
EMC conformance testing is based on the use of supplied and rec-
ommended cable types. The use of other cable types may degrade EMC
performance.
Changes or modifications not expressly approved by the manufac-
turer could void the user’s authority to operate the equipment.
Information to the user
This equipment has been tested and found to comply with the limits for a
Class B digital device, pursuant to Part 15 of the FCC Rules. These limits
are designed to provide reasonable protection against harmful interference
in a residential installation. This equipment generates uses and can radiate
radio frequency energy and, if not installed and used in accordance with
the instructions, may cause harmful interference to radio communications.
However, there is no guarantee that interference will not occur in a particu-
lar installation. If this equipment does cause harmful interference to radio
or television reception, which can be determined by turning the equipment
off and on, the user is encouraged to try to correct the interference by one
or more of the following measures:
•
Reorient or relocate the receiving antenna.
•
Increase the separation between the equipment and the receiver.
•
Connect the equipment to an outlet on a circuit different from that to
which the receiver is connected.
•
Consult the dealer or an experienced radio/TV technician for help.
WARNING:
Danger of explosion if battery incorrectly
replaced. Operate only with Shure compatible batteries.
WARNING:
Battery packs shall not be exposed to
excessive heat such as sunshine, fire, or the like.
