Ÿ
Ÿ
SET
4
3
2
1
8
7
6
5
The following messages may be display next to the bay number to indicate battery status:
calculating time to full
CALC
battery cold
COLD
battery warm
WARM
battery hot
HOT
recovery mode active
Recovery
error - press
SET
key for info
Error
Time to Full
Displays the time remaining until the battery is fully charged.
IMPORTANT:
Battery might not be charged to full capacity if any of the fol-
lowing status indicators appear:
Cold
Charging stopped because battery temperature is too cold. Charging will re-
sume when battery temperature increases.
Warm
Battery charging to less than full capacity (not less than 75%) because of
elevated temperature. The amber LED will illuminate when charging has
stopped.
Hot
Charging stopped because battery temperature is too hot.
Battery Health
This displays the health of a selected battery as a percentage of the charge
capacity of a new battery. Charge capacity (battery life when fully charged)
will decline as a result of repeated charge cycles, age, or storage conditions.
Cycle Count
Displays the total number of times that the battery has undergone one full
count of discharge and charge. Recharging after discharging half way counts
as one half of a cycle. Recharging after discharging a quarter of the way
counts as one quarter of a cycle.
Charge Status
Displays charge as a percentage of the total battery capacity. Also displays
charge in milliampere-hours (mAh).
Batt. Temp.
(Battery Temperature)
Displays both the battery temperature (in Celsius and Fahrenheit) and the
status, as follows:
[Normal]
Battery temperature = 0°C to 45°C (32°F to 113°F).
[Cold]
Battery temperature = 0°C (32°F) or lower.
[Warm]
Battery temperature = 45°C to 60°C (113°F to 140°F) .
[Hot]
Battery temperature = 60°C (140°F) or higher.
Note:
If warm or hot, try setting the fan to
Always On
or increasing ventilation
to the rack.
Network Status
Active
Indicates connectivity with other devices on the network.
Inactive
No connectivity with other devices on the network.
Note:
IP address must be valid to enable networked control.
Utility Menu
Press and hold both arrow keys to enter and exit the utility menu, which is
used to access network and display settings.
SET
hold both arrow keys
Device ID
This eight-character name is displayed when this device is detected on other
network devices or in WWB software.
1. Press
SET
key to enable editing.
2. Use the arrow keys to change the characters.
3. To finish editing, press the
SET
key until none of the characters are
highlighted.
IP Address Mode:
Automatic
This is the default setting for use with a DHCP server, which automatically
assigns an IP address.
1. Navigate to the IP Mode menu and press the
SET
key.
2. Use the arrow keys to highlight
Automatic
.
3. Press the
SET
key.
Shure Incorporated
AXT900
Rack Mount Charging Station
2017/10/10
4/7