SHUNFENG T4, Руководство пользователя

Страница: 33 / 62

Maintenance
29
U69M14E0.book Page 40 Monday, June 6, 2005 2:53 PM
Removing the propeller
Spline models
1. Straighten the split pin and pull it out us-
ing a pair of pliers.
2. Remove the propeller nut and washer.
3. Remove the propeller and thrust holder.
Installing the Propeller
Spline models
CAUTION:
●
Be sure to install the thrust holder be-
fore installing the propeller, otherwise
the lower case and propeller boss could
be damaged.
●
Be sure to use a new cotter pin and bend
the ends over securely. Otherwise the
propeller could come off during opera-
tion and be lost.
1. Apply corrosion resistant grease to
the propeller shaft.
2. Install the thrust holder , and propeller
on the propeller shaft.
3. Install the washer. Tighten the propeller
nut until there is no forward-and-backw -
ard movement.
4. Align the propeller nut with the propeller
shaft hole. Insert a new cotter pin in the
hole and bend the cotter pin ends.
NOTE:
If the propeller nut does not align with the pro-
peller shaft hole after tightening it, loosen the
nut until it aligns with the hole.
Changing gear oil
WARNING
●
Be sure the outboard motor is securely
fastened to the transom or a stable
stand. You could be severely injured if
the outboard motor falls on you.
●
Never get under the lower unit while it is
tilted, even when the tilt support lever or
knob is locked. Severe injury could oc-
cur if the outboard motor accidentally
falls.
1. Tilt the outboard motor so that the gear oil
2. Place a suitable container under the gear
case.
3. Remove the gear oil drain screw.
drain screw is at the lowest point possi-
ble.