showtech Phantom 50 KMII, Инструкция по эксплуатации

Страница: 31 / 40

30
Ordercode: 40200
Phantom 50 MKII
Replacing a gobo from the rotating gobo wheel
01) Disconnect mains power supply and set the switch to OFF.
02) Make sure that the gobo which you want to insert has the same size. For the right size, see below.
Fig. 07
Gobo Size
Fig. 08
03) Before removing the top part of the housing, make sure the lens is in the position as shown on the
left. The lens position should be on the bottom, symmetrically speaking.
04) Loosen all the four screws on the back of the housing.
05) Gently tilt the head so that the small metal housing slides out easily.
06) Turn the gobo wheel until you reach the gobo which you want to remove.