SHOWTEC Titan Strobe blaze, Руководство пользователя

Страница: 8 / 24

7
Ordercode: 40297
Titan Strobe BLAZE
Backside
Fig. 02
04) 16A circuit breaker (power switch ON/OFF)
05) 240V Pro power connector Blue IN
06) LCD d LED indicators and control buttons
07) 3-pin DMX signal connector OUT
08) 3-pin DMX signal connector IN
09) Cooling fan
10) 5-pin DMX signal connector OUT
11) 5-pin DMX signal connector IN
Installation
Remove all packing materials from the Titan Strobe BLAZE. Check if all foam and plastic padding is
removed. Connect all cables.
Do not supply power before the whole system is set up and connected properly.
Always disconnect from electric mains power supply before cleaning or servicing.
Damages caused by non-observance are not subject to warranty.
Installing the Lamp
The Showtec Titan Strobe BLAZE uses the Showtec PX-1500 Xenon flashtube lamp, 1500W (ordercode
82690 ). Use only the appropriate lamp for your unit. Note that product versions, that use other lamps, may
be offered in the future. Check your product specification label for information.
Always disconnect from electric mains power supply before changing lamps.
The lamp has to be replaced when it is damaged or deformed due to the heat.
Do not install lamps of higher wattage! Lamps of higher wattage generate temperatures which the
device was not designed for.
Damages caused by non-observance are not subject to warranty.
DANGEROUS: Leave the device disconnected for 15 minutes, before opening.
Otherwise, you risk electrocution.
01)
Disconnect from main power supply, and leave for 15 minutes.
02) Remove the glass cover. With the left hand, gently pull the lamp out of the spring, while pushing the
spring back with the right hand.
03) Remove the lamp. Read lamp instructions. Do not touch the lamp bulb glass. Oil on hands shortens
the lamp life. (If you touch the bulb glass, wipe off the glass with a clean, lint-free towel and rubbing
alcohol.) Hold the lamp with one hand and insert the lamp into the spring. Put the glass cover back.
Set Up and Operation
Follow the directions below, as they pertain to your preferred operation mode.
Before plugging the unit in, always make sure that the power supply matches the product specification
voltage. Do not attempt to operate a 120V specification product on 230V power, or vice versa.
Connect the device to the main power supply.