SHOWTEC Sunstrip Pro RGB, Руководство пользователя

Страница: 9 / 26

7
Installation
Remove all packing materials from the Sunstrip Pro RGB . Check that all foam and plastic padding is
removed. Connect all cables.
Do not supply power before the whole system is set up and connected properly.
Always disconnect from electric mains power supply before cleaning or servicing.
Damages caused by non-observance are not subject to warranty.
Set Up and Operation
Before plugging the unit in, always make sure that the power supply matches the product specification
voltage. Do not attempt to operate a 120V specification product on 230V power, or vice versa.
The display will shut down if no button is pressed for 15 seconds, and it will exit sleep mode if one of the 4
buttons is pressed. The refresh-rate of 400Hz, is ideal for TV approval.
Control Modes
There are 4 Modes: 1) Built-in Programs
2) Sound-controlled
3) Master/Slave
4) DMX512
One Sunstrip Pro RGB ( Built-in Programs )
1. Fasten the effect light onto firm trussing. Leave at least 0,5 meter on all sides for air circulation.
2. When the LED Tunnel Flower is not connected by a DMX-cable, it functions as a stand-alone device.
Please see page 12 ( Autoc Mode ) for more information about the built-in programs.
One Sunstrip Pro RGB (Sound-control)
1. Plug the end of the electric mains power cord into a proper electric power supply socket.
2. Turn on the music. If the device is set to Sound Program [1-16], then the sunstrip Pro RGB will react
to the beat of the music.
Multiple Sunstrips Pro RGB ( Master/Slave control)
1. Fasten the effect light onto firm trussing. Leave at least 0,5 meter on all sides for air circulation.
2. Use a 3-p XLR cable to connect the LED Tunnel Flower.
The pins:
1. Earth
2. Signal -
3. Signal +
3. Link the units as shown in (Fig. 3), Connect a DMX signal cable from the first unit's DMX "out"
socket to the second unit's "in" socket. Repeat this process to link the second, third, and fourth units.
You can use the same functions on the master device as described on this page (Built-in Programs and
Music control). This means on the master device you can set your desired operation Mode and all
slave devices will react the same as the master device.
Multiple Sunstrip Pro RGB ( Master/Slave control)
Fig. 3