SHOWTEC Pixelbar 16 Q6, Руководство пользователя

Страница: 18 / 44

17
Pixelbar 16 Q6
Product code: 41308
DMX Cables
Shielded twisted-pair cables with 3-pin/5-pin XLR connectors must be used for reliable DMX connection.
You can purchase DMX cables directly from your Highlite International dealer or make your own cables.
If you use XLR audio cables for DMX data transmission, this may lead to signal degradation and unreliable
operation of the DMX network.
When you make your own DMX cables, make sure that you connect the pins and wires correctly as
shown in Fig. 09.
Fig. 09
Master/Slave Setup
The Pixelbar 16 Q6 supports master/slave control mode. To connect multiple devices in master/slave
setup, follow the steps below:
Connect the first device’s DMX OUT connector to the second device’s DMX IN connector with a
3-pin/5-pin DMX cable.
Repeat step 1 to connect all devices as shown in Fig. 10.
Connect a DMX terminator (120 Ω resistor) to the DMX OUT connector of the last device in the setup.
Set the first device on the data link as a master device. See 6.6.7. Slave Mode on page 30 for more
information.
Set the remaining devices as slave devices. See 6.6.7. Slave Mode on page 30 for more information.
Fig. 10