SHOWTEC PHANTOM 300 LED MATRIX, Руководство пользователя

Страница: 11 / 40

Ordercode: 40060
Phantom 300 LED Matrix
Control Modes
There are 5 modes: • Built-in programs (Master mode)
• Manual
• Sound-controlled
• Master/Slave mode
• DMX-512, ArtNet (12CH, 20CH, 120CH)
One Phantom (Built-in Programs and Manual)
01) Fasten the effect light onto firm trussing. Leave at least 0,5 meter on all sides for air circulation.
02) Always use a safety cable (ordercode 70140 / 70141).
03) Plug the end of the electric mains power cord into a proper electric power supply socket.
04) When the Phantom is not connected with a DMX cable, it functions as a stand-alone device. Please
see page 22 for more information.
One Phantom (Sound-controlled)
01) Fasten the effect light to a firm trussing. Leave at least 0,5 meter on all sides for air circulation.
02) Plug the end of the electric mains power cord into a proper electric power supply socket.
03) Turn on the music. If the device is set to sound-control, then the Phantom will react to the beat of
the music. Please see page 22 for more information about the sound-control options.
Multiple Phantoms (Master/Slave Control)
01) Fasten the effect light onto firm trussing. Leave at least 0,5 meter on all sides for air circulation.
02) Always use a safety cable (ordercode 70140 / 70141).
03) Plug the end of the electric mains power cord into a proper electric power supply socket.
04) Use a 3-pin XLR cable to connect the Phantoms.
The pins: 01) Earth
02) Signal (-)
03) Signal (+)
05) Link the units as shown in (Fig.03). Connect a DMX signal cable from the first unit's DMX "out" socket to
the second unit's "in" socket. Repeat this process to link the second, third, and fourth units. You can
use the same functions on the master device as described on page 22. This means that you can set
your desired operation mode on the master device and all slave devices will react the same as the
master device.
Multiple Phantoms (Master/Slave Set Up)
Fig. 03
10