SHOWTEC Maniac FX 7, Руководство пользователя

Страница: 17 / 28

16
Order code: 41307
Maniac FX 7
4. DMX Settings
In this menu you can set the device’s DMX address and select the DMX channel mode.
01)
Press the MODE button to navigate through the Main Menu until the display shows .
02) Press the ENTER button to confirm the selection. The display shows the DMX starting address of the
device
.
03) Press the ENTER button open the submenu where you can choose the DMX channel modes.
04) Press the UP/DOWN buttons to navigate through the following 6 options:
3-channel mode DMX addressing range
4-channel mode DMX addressing range
6-channel mode DMX addressing range
10-channel mode DMX addressing range
12-channel mode DMX addressing range
15-channel mode DMX addressing range
05) Press the ENTER button to confirm the selected channel mode.
06) Press the UP/DOWN buttons to set the DMX address of the device. Refer to the DMX addressing
range per channel mode for the possible values.
07) Press the ENTER button to confirm the setting. The display will show the address of the fixture .
Note: If you do not press the ENTER button, the selected DMX address will be set automatically after
10 seconds, if no other button on the control panel is pressed.
5. Slave Mode Settings
In this menu you can set the device as slave.
01)
Press the MODE button to navigate through the Main Menu until the display shows .
02) Press the ENTER button to confirm. The menu will show and the display will be blinking. The
device is now operating in Slave Mode. It means that it will react the same as the master device.
6. System Settings
In this menu you can set the device as master and restore the factory defaults.
01)
Press the MODE button to navigate through the Main Menu until the display shows .
02) Press the ENTER button to open the submenu.
03) Press the UP/DOWN buttons to select one of the following 2 options:
Master mode settings
Factory defaults restore
04)
Press the ENTER button to confirm the selection.
●
When in the submenu , press the UP/DOWN buttons to choose between the following 2
options:
Master mode on, the device will perform as a master
Master mode off
Press the ENTER button to confirm your choice.
●
When in the submenu , press the ENTER button to confirm the reset of the device to
factory defaults. The display will show the current version of the firmware for 3 seconds: .
The device will return to the built-in Auto program and the display will show .