SHOWTEC FLEXSTRIP SET IP4RGB, Руководство пользователя

Страница: 10 / 12

9
Ordercode: 42771
Flexstrip Set IP44 RGB
Maintenance
The operator has to make sure that safety-related and machine-technical installations are to be
inspected by an expert after every year in the course of an acceptance test.
The operator has to make sure that safety-related and machine-technical installations are to be
inspected by a skilled person once a year.
The following points have to be considered during the inspection:
01)
All screws used for installing the device or parts of the device have to be tightly connected and
must not be corroded.
02) There may not be any deformations on housings, fixations and installation spots.
03) Mechanically moving parts like axles, eyes and others may not show any traces of wearing.
04) The electric power supply cables must not show any damages or material fatigue.
The Flexstrip Set IP44 RGB requires almost no maintenance.
However, you should keep the unit clean.
Otherwise, the fixture’s light-output will be significantly reduced. Keep connections clean. Disconnect
electric power, and then wipe the Flexstrip with a cloth. Do not use alcohol or solvents.
Troubleshooting
No Light
This troubleshooting guide is meant to help solve simple problems.
If a problem occurs, follow the steps below in sequence until a solution is found. Once the unit operates
properly, do not carry out the following steps.
If the light effect does not operate properly, refer servicing to a technician.
Response: Suspect two potential problem areas: power supply and the LEDs.
01)
Power supply. Check that the unit is plugged into an appropriate power supply.
02) The LEDs. Return the Flexstrip Set IP44 RGB to your Showtec dealer.
03) If all of the above appears to be in order, switch the unit on again.
04) If you are unable to determine the cause of the problem, do not open the Flexstrip Set IP44 RGB , as
this may damage the unit and the warranty will become void.
05) Return the device to your Showtec dealer.
Problem Probable cause(s) Solution
The device does
not function at all
No power to the device
• Check if power is switched on and
cables are plugged in
LEDs damaged
• Disconnect the device and return
it to your dealer
The power supply settings do not
match local AC voltage and
frequency • Disconnect the device. Check
settings and correct if necessary
The device works
correctly but
responds
erratically or not
at all to the
remote control
The remote control battery is flat
• Replace the battery of the remote
control
No light or lamp
cuts out
intermittently
Device is too hot
• Allow the device to cool down
• Turn up the air conditioning
LEDs damaged
• Disconnect the device and return
it to your dealer