SHOWTEC Festoonlight Q4 String, Руководство пользователя

Страница: 10 / 12

9
Ordercode: 41751
Festoonlight Q4 String
Setup and Operation
Follow the directions below, as they pertain to your preferred operation mode.
Before plugging the unit in, always make sure that the power supply matches the product specification
voltage. Do not attempt to operate a 120 V specification product on 230 V power, or vice versa.
After you have connected the Festoonlight String(s) to the Festoonlight Controller you can supply electric
power to the setup.
The Festoonlight Q4 String is compatible only with the Festoonlight Q4 Controller. Refer to the user manual
of the Festoonlight Q4 Controller for more information about the various operation modes and
possibilities.
With the Festoonlight Q4 Controller you can play one of the 30 built-in programs. To control each of the
20 pixels on the string individually, you will need to set up a DMX or Art-Net connection to a computer or
a lighting controller.
The Festoonlight Q4 String is not intended for permanent operation.
Maintenance
Inspect all parts and mounting points of the Festoonlight Q4 String before use. Do not use if parts are
weakened, discolored, brittle, or otherwise degraded, damaged, or worn.
The Festoonlight Q4 String requires almost no maintenance. However, you should keep the unit clean.
Disconnect the mains power supply, and then wipe the bulbs with a damp cloth. Do not immerse in
liquid. Do not use alcohol or solvents.
Keep connections clean. Disconnect electric power, and then wipe the connections with a damp cloth.
Make sure connections are thoroughly dry before linking equipment or supplying electric power.
Troubleshooting
This troubleshooting guide is meant to help solve simple problems.
If a problem occurs, carry out the steps below in sequence until a solution is found. Once the unit
operates properly, do not carry out following steps.
Problem
Probable cause(s) Solution
No light at all
No power to the fixture
● Check if power is switched on and
cables are plugged in
Defective DMX source ● Replace DMX source
Bad data link
● Inspect the RJ45 connectors and
correct poor connections
Incorrect addressing ● Check addresses and protocol settings
Defective LED ● Replace LED string
No light in one LED
ball
No DMX signal is received from
source
● Replace DMX source
● Check DMX addressing and protocol
settings
Defective DMX source ● Replace DMX source
Incorrect addressing
● Check DMX addressing and protocol
settings
Defective LED ● Replace LED string
Low light output from
a LED ball near the
end of the string
Insufficient voltage from power
source
● Check power source specifications
and replace power source if necessary
● Inspect power source for defects and
repair or replace power source