SHOWTEC EventLITE 4/10 Q4 Set 6x, Руководство пользователя

Страница: 14 / 40

13
Ordercode: 44061
EventLITE 4/10 Q4 Set 6x
One EventLITE (Built-in programs)
01) Fasten the effect light to a firm trussing. Leave at least 0,5 meter on all sides for air circulation.
02) Plug the end of the electric mains power cord into a proper electric power supply socket.
03) When the EventLITE is not connected with a DMX cable and Wireless DMX is switched off, it functions
as a stand-alone device. See page 25 for more information about Built-in programs.
One EventLITE (Manual)
01) Fasten the effect light to a firm trussing. Leave at least 0,5 meter on all sides for air circulation.
02) Plug the end of the electric mains power cord into a proper electric power supply socket.
03) When the EventLITE is not connected with a DMX cable and Wireless DMX is switched off, it functions
as a stand-alone device. See page 24 for more information about Manual mode.
Multiple EventLITEs (Master/Slave control)
01)
Fasten the effect light onto firm trussing. Leave at least 0,5 meter on all sides for air circulation.
02) Always use a safety cable (ordercode 70140 / 70141).
03) Use a 3-pin XLR cable to connect the EventLITE and other devices.
The pins: 1. Earth
2. Signal (-)
3. Signal (+)
04)
Link the units as shown in Fig. 06. Connect a DMX signal cable from the first unit's DMX "out" socket to
the second unit's "in" socket. Repeat this process to link the second, third and fourth unit. You can use
the same functions on the master device as described on pages 24–25 (Manual, Auto or Built-in
programs). This means that you can set your desired operation mode on the master device and all
slave devices will react the same as the master device.
Multiple EventLITEs
( Master/Slave control)
Fig. 06