SHOWTEC EventLITE 4/10 Q4 Set 6x, Руководство пользователя

Страница: 12 / 40

11
Ordercode: 44061
EventLITE 4/10 Q4 Set 6x
Installation
Remove all packing materials from the EventLITE 4/10 Q4 Set . Check if all foam and plastic padding is
removed. Connect all cables.
Do not supply power before the whole system is set up and connected properly.
Always disconnect from electric mains power supply before cleaning or servicing.
Damages caused by non-observance are not subject to warranty.
Adjusting the Tilt Angle
It is possible to adjust the tilt angle of the EventLITE.
01)
Press and hold down the bracket button and tilt the EventLITE to the desired position.
Fig. 04
02)
Release the bracket button to secure the EventLITE in position.
Setup and Operation
Before plugging the unit in, always make sure that the power supply matches the product specification
voltage. Do not attempt to operate a 110 V specification product on 240 V power, or vice versa.
Charging the Built-in Battery
01) Press the power buttons (11), at the bottom of each EventLITE, to turn the power off.
02) Place the EventLITEs in the charging case.
03) Plug the IEC outlet cables (21) into the IEC inputs (09) on the EventLITEs.
04) Plug one end of the included pro power cable into the pro power input (17) on the charging case.
Plug the other end of the cable into a proper electric power supply socket. The power indicator (22)
will light red.
05) Charge the battery (up to 10 hours.)