7
Installation
Remove all packing materials from the
DB-1-8
. Check that all foam and plastic padding is removed.
Connect all cables.
Do not supply power before the whole system is set up and connected properly.
Always disconnect from electric mains power supply before cleaning or servicing.
Damages caused by non-observance are not subject to warranty.
Set Up and Operation
Before plugging the unit in, always make sure that the power supply matches the product specification
voltage. Do not attempt to operate a 120V specification product on 230V power, or vice versa.
Remove all packing materials from the DB-1-8. Check that all foam and plastic padding is removed.
You will need a serial data link to run light shows of one or more fixtures using a DMX-512 controller or to
run synchronized shows on two or more fixtures set to a master/slave operating mode. The combined
number of channels required by all the fixtures on a serial data link determines the number of fixtures the
data link can support.
DMX Setup Example
1.
Fasten the movingheads onto firm trussing. Leave at least 0,5 meter on all sides for air circulation.
2.
Always use a safety cable (ordercode 70140 / 70141).
3.
Use a 3-p XLR cable to connect the
movingheads
and other devices.
4.
Link the units as shown in (figure 3), Connect a DMX signal cable from the DMX controller's DMX "out"
socket to the first DB-1-8 "in" socket. Connect another DMX signal cable from the first DB-1-8 DMX "out"
socket to the first unit's "in" socket. Repeat this process to link the second, third, and fourth units.
5.
Supply electric power: Plug electric mains power cords into each unit's IEC socket, then plug the
other end of the mains power cord into proper electric power supply sockets, starting with the first
unit. Do not supply power before the whole system is set up and connected properly.
Содержание DB-1-8
Страница 15: ......
