SHOWTEC City Painter 150, Руководство по эксплуатации продукта

Страница: 14 / 20

12
“2P” Function Mode switches and Address Dip switches
Stand-alone Mode
The fixtures on a data-link are not connected to the controller, but can execute pre-set programs, which can
be different for every fixture. To set the program to be played, see the page 14.
When you want to use stand-alone mode set the “2P” dip switch 1 to “ON” and 2 to “OFF”, as below:
Stand-alone operation” can be applied to a single fixture (the fixture may be set to the master/slave mode
or controller mode) or to multiple fixture operating synchronously.
Master / Slave Mode
For synchronous operation of multiple fixtures the fixtures must all be connected on a data-link and one of
them is set as a master (master mode DIP switch 1 ON) and the rest as slaves (slave mode DIP switch 1
OFF). The DMX address of all the slaves are assigned and on that particular slave address only one fixture
can be connected.
Master Slave
If the master fixture resets or runs a test (program), all slaves will execute these acts too.
Note: Disconnect the fixtures from the DMX controller before master/slave operating, otherwise data
collisions can occur and the fixtures will not work properly!
It’s necessary to insert the XLR termination plug (with 120 Ohm) into the input of the master fixture and into
the output of the last slave fixture in the data-link, in order to ensure proper transmission on the data link.
From the master’s control panel it is possible to control any slave in a master/slave chain.