SHOWTEC Aircone Q6 WDMX, Руководство пользователя

Страница: 14 / 28

13
Ordercode: 40314
Aircone Q6 WDMX
The Aircone Q6 WDMX can be operated with a controller in control mode or without the controller in
stand-alone mode.
Control Panel
A) LED display
B) MODE button
C) SETUP button
D) UP button
E) DOWN button
Fig. 05
Control Mode
The fixtures are individually addressed on a data-link and connected to the controller.
The fixtures respond to the DMX signal from the controller. (When you select the DMX address and save it,
the controller will display the saved DMX address, next time.)
DMX Addressing
The control panel on the front side of the base allows you to assign DMX fixture addresses, which is the first
channel with which the Aircone will respond to the controller.
Please note, when you use the controller, the unit has 12 channels.
When using multiple Aircones, make sure you set the DMX addresses right.
Therefore, the DMX address of the first Aircone should be 1(001); the DMX address of the second Aircone
should be 1+12=13 (013); the DMX address of the third Aircone should be 13+12=25 (025), etc.
Please, be sure that you do not have any overlapping channels in order to control each Aircone
correctly. If two or more Aircones are addressed similarly, they will work similarly.
Controlling:
After having addressed all Aircone fixtures, you may now start operating these via your lighting controller.
Note: After switching on, the Aircone will automatically detect whether DMX 512 data is received or not.
If there is no data received at the DMX-input, the “LED “ on the control panel will not flash.
If not, the problem may be:
•
The XLR cable from the controller is not connected with the input of the Aircone Q6 WDMX.
• The controller is switched off or defective, the cable or connector is detective, or the signal wires are
swapped in the input connector.
Note: It is necessary to insert an XLR termination plug (with 120 Ohm) in the last fixture in order to ensure
proper transmission on the DMX data link.
Display Off after 60 seconds
When no button is pressed for 60 seconds, the display will turn off.
To light up the display, you have to press the MODE, SETUP, UP or DOWN button.
Once you have pressed the button, the display will light up.