SHOWTEC Aircone Q6 WDMX, Руководство пользователя

Страница: 11 / 28

10
Ordercode: 40314
Aircone Q6 WDMX
Control Modes
There are 6 modes:
• Stand-alone (Auto)
• Built-in programs
• Manual
• Sound-controlled
• Master/Slave
• DMX-512 (3CH, 6CH, 6CH, 12CH)
One Aircone (Auto, Built-in programs and Manual)
01)
Fasten the effect light to a firm trussing. Leave at least 0,5 meter on all sides for air circulation.
02) Plug the end of the electric mains power cord into a proper electric power supply socket.
03) When the Aircone is not connected with a DMX cable, it functions as a stand-alone device.
Please see page 15 for more information about Auto, Built-in programs and Manual mode.
One Aircone (Sound-controlled)
01)
Fasten the effect light to a firm trussing. Leave at least 0,5 meter on all sides for air circulation.
02) Plug the end of the electric mains power cord into a proper electric power supply socket.
03) Turn on the music. If the device is set to sound-control, then the Aircone will react to the beat of the
music. Please see page 16 for more information about the sound-control options.
Multiple Aircones (Master/Slave control)
01)
Fasten the effect light onto firm trussing. Leave at least 0,5 meter on all sides for air circulation.
02) Use a 3-pin XLR cable to connect the Aircone.
The pins: 01) Earth
02) Signal -
03) Signal +
03) Link the units as shown in fig. 03. Connect the first unit's DMX "out" socket with the second unit's "in"
socket, using a DMX signal cable. Repeat this process to link the second, third, and fourth units.
You can use the same functions on the master device as described on pages 15-16 (Auto, Built-in
programs, Manual or Sound-controlled mode). This means that you can set your desired operation
mode on the master device and all slave devices will react the same as the master device.
Multiple Aircones (Master/Slave control)
Fig. 03