SHOWTEC Aircone 1W LED, Руководство по эксплуатации продукта

Страница: 12 / 22

11
Control Panel
Fig. 3
A.
Static mode indicator E. Mode button
B. Display F. Up button
C. DMX signal indicator G. Down button
D. DMX mode indicator
DMX Control Mode
The fixtures are individually addressed on a data-link and connected to the controller. When the Aircone
LED 1W is in DMX mode, the
DMX mode indicator (D) and the DMX signal indicator (C) will light up. While
receiving a DMX signal, the DMX signal indicator (C) will blink.
The fixtures respond to the DMX signal from the controller. (When you select the DMX address and save it,
the controller will display the saved DMX address the next time.)
DMX Addressing
The control panel on the front side of the base allows you to assign the DMX fixture address, which is the
first channel from which the Aircone LED 1W will respond to the controller.
Please note when you use the controller, depending on the DMX mode you’re in, the unit has up to
7
channels (DMX mode 4).
When using multiple Aircone LED 1Ws, make sure you set the DMX addresses right.
So, if you’re in DMX mode 4, the DMX address of the first Aircone LED 1W should be
1(001) ; the DMX
address of the second Aircone LED 1W should be 1+7=8 ; the DMX address of the third Aircone LED 1W
should be 8+7=15 , etc.
Please, be sure that you don’t have any overlapping channels in order to control each Aircone LED 1W
correctly. If two or more Aircone LED 1Ws are addressed similarly, they will work similarly.
Controlling:
After having addressed all Aircone LED 1Ws, you may now start operating these via your lighting
controller.
Note: After switching on, the Aircone LED 1W will automatically detect whether DMX 512 data is received
or not. If there is no data received at the DMX-input, the DMX signal indicator (C) on the control panel
will dim.
The problem may be:
• The XLR cable from the controller is not connected with the input of the Aircone LED 1W.
• The controller is switched off or defective, the cable or connector is detective, or the signal wires are
swapped in the input connector.
Note: It’s necessary to insert a XLR termination plug (with 120 Ohm) in the last fixture in order to ensure
proper transmission on the DMX data link.