SHOWTEC ACT Fresnel 50 WW, Руководство пользователя

Страница: 18 / 28

17
Order code: 34011
ACT Fresnel 50 WW
1.1 DMX Address
In this pop-up submenu you can set the starting DMX address of the device.
01)
Press the UP/DOWN buttons to select the starting DMX address of the device. The selection range is
between 1 and 512.
02) Press the ENTER button to confirm the selection.
1.2 DMX Channel Mode
In this pop-up submenu you can select the DMX channel mode.
01)
Press the UP/DOWN buttons to select the desired DMX channel mode. There are 2 options available:
1 Channel
2 Channel
02) Press the ENTER button to confirm the selection.
1.3 DMX Fail
In this pop-up submenu you can determine the behavior of the device in case of a DMX signal failure.
01)
Press the UP/DOWN buttons to select one of the following 3 options:
● Manually Defined: The device will use the dimmer value selected with the manual dimmer
control (15) in manual mode. Refer to One ACT Fresnel (Manual Control) on
page 11 for more information
● Hold: The device will use the last properly received DMX signal
● Blackout: The device will black out the light output
02) Press the ENTER button to confirm your choice.
1.4 View DMX Value
In this submenu you can view the currently selected DMX value for each DMX channel. If you have
selected 1-channel DMX mode, only the Dimmer value will be visible on the screen. If you have selected
2-channel DMX mode, both the Dimmer and the Strobe values will be visible on the screen.
1-channel DMX mode 2-channel DMX mode