8
Set Up and Operation
Follow the directions below, as they pertain to your preferred operation mode.
Before plugging the unit in, always make sure that the power supply matches the product specification
voltage.
Damages caused by non-observance are not subject to warranty.
Control Modes
There are 3 modes:
• Manual Mode
• Sound-controlled
• DMX512
One Compact Studiobeam (
Manual Mode
)
1.
Fasten the effect light onto firm trussing. Leave at least 0,5 meter on all sides for air circulation.
2.
Plug the end of the electric mains power cord into a proper electric power supply socket.
3.
When the Compact Studiobeam is not connected by a DMX-cable, it functions as a stand-alone
device. Please see page 13 for more information about the
Manual Mode.
One Compact Studiobeam (Sound-control)
1.
Fasten the effect light onto firm trussing. Leave at least 0,5 meter on all sides for air circulation.
2.
Plug the end of the electric mains power cord into a proper electric power supply socket.
3.
Turn on the music. If device is set to (Audio) and you have pressed enter, then the fixture
will react to the beat of the music.
Please see page 14 for more information about the sound-control
options
.
Multiple Compact Studiobeams (DMX Control)
1.
Fasten the effect light onto firm trussing. Leave at least 0,5 meter on all sides for air circulation.
2.
Always use a safety cable (ordercode 70140 / 70141).
3.
Use a 3-p XLR cable to connect the
Compact Studiobeam
and other devices.
4.
Link the units as shown in (figure 3), Connect a DMX signal cable from the first unit's DMX "out" socket
to the second unit's "in" socket. Repeat this process to link the second, third, and fourth units.
5.
Supply electric power: Plug electric mains power cords into each unit's IEC socket, then plug the
other end of the mains power cord into proper electric power supply sockets, starting with the first
unit. Do not supply power before the whole system is set up and connected properly.
Содержание 42498
Страница 20: ......
