6
Remove package and check:
Open carton to check whether all necessary parts are included according the specification
list. Please contact your distributor if there is something missing. Check the appearance of
the machine and all accessories to see whether there is some obvious damage. Please
contact distributor once you find something abnormal and stop using the fog machine.
Installation:
Take away all pack material especially the spray mouth. Place the fog machine in horizontal
position (ground) on a solid flat surface. Do not spray fog to people directly and the lean
angle should be less than 15
°
.
Open the cover of liquid can. Add high quality fog liquid in the machine and close the cover
of liquid can. Bad quality fog liquid can damage the fog machine. Check if your net voltage
specification is correct. Plug in the cable for remote control and power cord in the sockets at
the back of the machine.
Blug in timer and ration controller (“ADJUST” connector).
Operation:
Switch on the power at the back of the machine and the fog machine will start to heat up
(ca. 12 minutes). Press the start key and the machine starts to spray fog (press it as long as
you need).
Always check if there is enough fog liquid in the machine.
If there is no fog liquid in the machine the device may
overheat and can be damaged.
Maintenance:
Please clean the fog machine after using to avoid damage.
Don’t make the fog machine be
dirty, avoid dust and moisture. Close the cover of liquid can after adding fog liquid. After
about 40 hours of use, please use 80% distilled water and 20% vinegar to clean the dirt in
refractory pipe. Disassemble the spray mouth and use vinegar to clean it to keep expedite
before heat. Add fog liquid for next use and keep the cap of tank always closed during
transportation and operation.
Store the machine at a dry and safe place
E
N
G
L
I
S
H
