9
Maintenance
The operator has to make sure that safety-relating and machine-technical installations are to be
inspected by an expert after every year in the course of an acceptance test.
The operator has to make sure that safety-relating and machine-technical installations are to be
inspected by a skilled person once a year.
The following points have to be considered during the inspection:
1.
All screws used for installing the device or parts of the device have to be tightly connected and must
not be corroded.
2.
There may not be any deformations on housings, fixations and installation spots.
3.
Mechanically moving parts like axles, eyes and others may not show any traces of wearing.
4.
The electric power supply cables must not show any damages or material fatigue.
The
Showtec Easy Fade 36
requires almost no maintenance. However, you should keep the unit clean.
Disconnect the mains power supply, and then wipe the cover with a damp cloth. Do not immerse in
liquid. Do not use alcohol or solvents.
Keep connections clean. Disconnect electric power, and then wipe the DMX and audio connections
with a damp cloth. Make sure connections are thoroughly dry before linking equipment or supplying
electric power.
Troubleshooting
No Light
This troubleshooting guide is meant to help solve simple problems.
If a problem occurs, carry out the steps below in sequence until a solution is found. Once the unit
operates properly, do not carry out following steps.
If the Easy Fade 36 does not operate properly, refer servicing to a technician.
Response: Suspect two potential problem areas: the power supply, the LEDs.
1.
Power supply. Check that the unit is plugged into an appropriate power supply.
2.
The LEDs. Return the Easy Fade 36 to your Showtec dealer.
3.
A led effect does not respond to the Easy Fade 36: Check the DMX-address of the fixture and the
controller. Make sure they match. Make sure the connections are correct. Check if blackout is off.
4.
If all of the above appears to be O.K., plug the unit in again.
5.
If nothing happens after 30 seconds, unplug the device.
6.
If you are unable to determine the cause of the problem, do not open the Easy Fade 36, as this may
damage the unit and the warranty will become void.
7.
Return the device to your Showtec dealer.
No Response to DMX
Response: Suspect the DMX cable or connectors, a controller malfunction, a light effect DMX card
malfunction.
1.
Check the DMX setting. Make sure that DMX addresses are correct.
2.
Check the DMX cable: Unplug the unit; change the DMX cable; then reconnect to electrical power.
Try your DMX control again.
3.
Determine whether the controller or light effect is at fault. Does the controller operate properly with
other DMX products ? If not, take the controller in for repair. If so, take the DMX cable and the light
effect to a qualified technician.
Содержание Easy Fade 36
Страница 1: ...Easy Fade 36 ORDERCODE 50711...
Страница 13: ......
